koban KMD 05 Manual De Instrucciones página 17

• Always be careful when working with voltages above 60V DC or 30V
AC rms. Keep fingers behind the probe barriers when making voltage
measurements.
• Make sure the test leads are in the correct input jacks before measurement.
• Do not expose the meter to explosive gas, dust or vapor.
• Whe connecting the test leads to a measurement circuit, connect the
common lead first, the the live lead. Reverse when disconnecting.
• Turn off the power to circuit and discharge all capacitors before making
resistance, continuity or diode measurements.
• In order to avoid incorrect DC voltage readings, check the circuit for AC
voltage first, then put the meter in the appropriate DC voltage range.
• Turn off circuit power and check fuses before connect the leads when
measuring current. Turn circuit power on after making connection.
• Never use the meter unless the back cover is in place and fastened securely.
• When de low battery indicator
accuracy of the meter cannot be guaranteed while the low battery indicator
is on.
• Before opening the case, always disconnect test leads from all energized
circuits.
• For continued protection against fire, replace fuse only with the specified
voltage and current ratings listed in the manual.
Electrical symbols
Caution: refer to the instruction manual. Incorrect use may
result in damage to the device or its components.
AC (Alternating Current)
DC (Direct Current)
AC or DC
Conforms to European Union directives
High risk
Earth ground
Double insulated
Fuse
www.grupotemper.com
Digital multimeter
is displayed, replace the battery. The
Instructions manual |
KMD 05
17