WARRANTY
Certificate of warranty
Ravelli thanks you for the trust granted with the purchase of one of its products and invites the purchaser to:
- read the installation, use and maintenance instructions for the product.
- read the warranty conditions contained below.
Warranty conditions
The warranty for the Customer is acknowledged by the Dealer under the terms of law. The warranty certificate must be completed in all
of its parts. The Customer is responsible for ensuring that the Dealer completes and sends (or sends itself) the warranty certificate and a
copy of the tax receipt/invoice within 8 days from date of purchase.
The warranty certificate and copy of the tax receipt/invoice must be sent to the following address:
The Dealer acknowledges the warranty only if the product has not been tampered with and only if it has been installed in accordance with
the Manufacturer's instructions.
The limited warranty covers manufacturing material defects, as long as the product has not broken sue to an incorrect use, negligence,
incorrect connection, tampering, installation errors.
The warranty becomes null and void even if only one requirement in this manual is not complied with.
The following are not covered by warranty:
•
vermiculite (firex 600)
•
the door glass;
•
the fibre seals;
•
the paint;
•
the combustion basket in stainless steel or cast iron;
•
the resistor;
•
the coloured majolica:
•
any damages caused by unsuitable installation and/or use of the product and/or shortcomings on the part of the customer.
The use of poor quality pellet or any other material that may damage the product's components, cause its warranty to be voided and as a
result eliminate the connected manufacturer liability.
It is therefore recommended to use pellet that matches the requirements listed in the dedicated chapter.
All damages caused by transportation are not recognised, for this reason it is recommended to carefully check goods upon receipt,
immediately warning the reseller of any damage.
Info and problems
Dealers authorised by Ravelli use a trained Technical Service Centre network to meet the Customer's requirements. For any information
or request for assistance, the Customer is asked to contact its Dealer or Technical Service Centre.
Use and maintenance manual
Ravelli presso Aico SpA
Via Kupfer, 31
25036 Palazzolo s/O
Brescia (ITALY)
HR EVO 200-250 SMART
Rev.0 21/12/2020
Pag.11