Technical Characteristics - Ravelli HR EVO 200 SMART Manual De Uso Y Mantenimento

TECHNICAL CHARACTERISTICS

The boiler works exclusively on pellets and enables easy installation with the heating and DHW system. Its automatic control systems
ensure optimum thermal efficiency and complete combustion; there are also systems to ensure safe operation for the internal
components and the user. This unit must only be used for heating water to a temperature lower than boiling point.
When correctly installed, the unit works in any outside climatic conditions; in any case, in critical conditions (strong wind, frost, etc. )
the safety systems can cut in and shut down the boiler.
The boiler comes complete with a fume extractor, pellet feed gearmotor, , high efficiency pump for the heating circuit and of all the
control and safety components. During operation the unit generates very little noise, with levels between 38 and 42 dB.
The data shown here is provided as a guideline and is not binding, and may change based on what type and quality of pellet is used.
Ravelli reserves the right to make any changes in order to improve product performance.
TECHNICAL CHARACTERISTICS
Boiler class (EN 303-5:2012)
Heating input reduced - nominal
Heating output reduced - nominal
Efficiency reduced - nominal
Useful efficiency
Seasonal space heating energy efficiency
Fuel consumption red. - nom
Autonomy red. - nom.
Heatable volume**
CO 13% O
2
CO 10% O (seasonal)
2
NOx 13% O
2
NOx 10% O (seasonal)
2
PM 13% O
2
PM 10% O (seasonal)
2
OGC 13% O
2
OGC 10% O (seasonal)
2
Max working pressure
Maximum adjustable water temperature
Temperatura max acqua
Water content
Expansion vessel
Flue gas temperature red. - nom.
Flue mass flow rate red.-nom.
Draught
Eletrical supply
Electrical consumption Start*
Electrical consumption nom.*
Electrical consumption red*
Electrical consumption stand-by*
Maximum electric consumption of pump
Hopper capacity
Condensing Boiler
Cogeneration boiler
combination boiler
It is recommended that the boiler be
operated with a hot water storage tank of
a volume of at least
*Characteristic which may vary according to the type of used fuel.
** Heatable volume based on the requested power per m³.
Use and maintenance manual
Unit of
measure
mg/m
mg/m
mg/m
mg/m
mg/m
mg/m
mg/m
mg/m
bar (kPa)
Pa (mbar)
V - Hz
HR EVO 200-250 SMART
HR EVO 200 SMART
5
kW 6 - 21,6
kW 5,6 - 20,0
% 92,8 - 92,5
% 84,2 - 84,7
% 79
kg/h 1,29 - 4,58
h 11 - 39
m 480
3
328 - 17
3
387
3
74 - 104
3
108
3
7,9 - 9,6
3
11
3
2,8 - 0,5
3
3
3
2 (200)
°C 80
°C 90
l 39
l 6
°C 67 - 109
g/s 7 - 11,6
9 (0,09)
230 V- 50 Hz
W 300
W 100
W 61
W 6
W 43
kg 50
NO
NO
NO
l 400
Rev.0 21/12/2020
Pag.19
HR EVO 250 SMART
5
6 - 27,3
5,6 - 25,3
92,8 - 92,4
84,2 - 84,6
79
1,29 - 5,8
9 - 39
605
328 - 5
384
74 - 113
110
7,9 - 9,8
11
2,8 - 0,4
3
2 (200)
80
90
39
6
67 - 126
7 - 13,8
9 (0,09)
230 V- 50 Hz
300
106
61
6
43
50
NO
NO
NO
506