Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Step 2. Removing Springs
With 7/16" wrench, hold fixed cube nut in place.
1
Remove spring from spring anchoring bar.
3
Repeat steps 1 to 4 on remaining springs.
5
Spring Anchoring Bar
Fixed Cube Nut
REQUIRED TOOLS:
Using second 7/16" wrench on opposite side
2
of spring anchoring bar, loosen nylon locknut.
This may require a bit of torque.
used nylon locknuts. (New nylon
NOTE: DISCARD
locknuts are provided with new springs.)
Pull spring out of the plastic spring holder.
4
Remove spring sleeves from old springs
6
and slide onto new springs, if applicable.
-
TWO OPEN
END WRENCHES
1/2" (13
)
7/16" (11
)
MM
X
MM
13
Publicidad
Tabla de contenido
