How To Assemble Your Ceiling Fan - Fanimation ROTATION FP8018 Serie Manual De Usuario

CAUTION
To prevent damage to housing and/or blade, leave the
Ceiling Fan Assembly in its original packing during
installation of down rod, motor coupling cover and
ceiling canopy. (Figure 1)
NOTE: Do not set Ceiling Fan Assembly on fl oor or hard
surface. Prior to assembly, set aside and save the hardware
bag(s) packed in the packing.
1. Remove the hairpin clip and clevis pin from the bottom
of the downrod support
reinstallation in Step 3. (Figure 2)
2. The fan comes with black, white and green wires ,
as well as a safety cable. Separate and untwist the wires.
Route the wires and safety cable through the downrod.
(Figure 3)
3. Be sure to line up the holes while pushing the downrod
into the downrod support prior to installing clevis pin
and hairpin clip. (Figure 3 & Figure 4)
▲WARNING
It is critical that the clevis pin in the downrod support
is properly installed. Failure to verify that the pin and
hairpin clip are properly installed could result in the fan
falling.
4. Slide the motor coupling cover down the downrod
until it touches the top of the motor, then slide the ceiling
canopy down the downrod as well. (Figure 5)

How to Assemble Your Ceiling Fan

. Retain the pin and clip for
Hairpin Clip
Black, White, Green
and Safety Cable
Hairpin Clip
7
Figure 1
Clevis Ping
Figure 2
Line up the
holes for clevis
pin installation
Figure 3
Clevis Ping
Figure 4
Ceiling Canopy
Motor Coupling
Cover
Figure 5