Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5. OPERATION
DANGER! Risk of injury due to electric shock.
Warning! Do not plug in before installation is fully completed!
Setting up your lawn mower
Set up the lawn mower on flat and firm ground to ensure safe and sturdy operating.
Insert the lower handle
self-tapping screw.
Fix the upper
and lower handles
3
hand and rotate the knob with a little bit force.
The main module of the switch box group is pointed at the side module on the right of the
upper handle
and lightly push the button.After locking, cross the main module down again
3
to confirm whether the installation is complete.
Fasten the power cord to the handle with two wire clips
Risk of death by electrocution or electric shock or serious personal
injury if power lines or electric cords are contacted. Never operate
mower over electrical sources, cords, or wires.
Adjust the handle height
There are two different holes on the side of the lower handle
If the height seems too tall or too short, adjust the hole properly and tighten it with the self-
tapping screw.
Installing the grass collection box
Before installing, make sure the grass box has been properly attached to the metal grass
collection box
frame via the clips around the mouth of the box.
7
Lift the rear discharge door
with handle side up into the grooves under the hinge of the rear discharge door
7
making sure that the hooks rest properly inside their respective grooves.
After stopping, lift the rear discharge door
Setting the cutting height
When shipped,the wheels on the mower are set to a low-cutting position.Before using the
into the handle fixing hole of the mower and tighten it with the
13
with the knob
13
. While holding the door open, place the grass collection box
12
, take the grass collection box
12
235
235
. Hold the bolt by pushing with your
5
.
4
to vary the height.
13
7
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
,
12
away.
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
