peerless-AV PLA60-UNLP-GB Manual De Instalación página 13

9 Depending on the specific size & weight of the plasma,
articulating swing arm may be angled at different
positions, causing plasma to appear to lean sideways
at different articulating positions. Tilt-roll assembly (B)
allows plasma to be manually adjusted, so plasma can
be horizontal at all positions. To adjust, gently rotate
plasma by hand to desired position.
ARTICULATING
ARM
FOR PLAV 60 ONLY:
10 Position of screen may be adjusted vertically up to
.79" in each direction by doing the following:
• To lower screen, turn socket screw shown in figure
10.1 clockwise with 10 mm allen wrench (V).
• To raise screen, turn socket screw shown in figure
10.1 counterclockwise with 10 mm allen wrench (V).
SOCKET
SCREW
PLASMA
fig 10.1
9-1
If it is too difficult to adjust roll of plasma, loosen
screws shown in figure 9.1 using a phillips screw-
driver.
IMPORTANT! Do not loosen or tighten screws
more than 1/8 turn.
ADJUSTMENT
SCREWS
ROLL
fig 9.1