Manual Operation - Kalorik USK CCG 1 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

the non-drip valve and allows remaining coffee to filter trough
into the jug.
Once the water tank is empty, we advise you to wait until the
brewing process is finished and the filter has run empty before
removing the jug.

MANUAL OPERATION

Slide the release button of the lid of the water tank and lift it. Fill
the water tank with cold water. The number of cups can be read
on the graduated water tank. Close the lid.
Pull the filter holder out using its handle, fill the permanent filter
with the desired quantity of ground coffee or use the grinder (see
"USING THE COFFEE GRINDER" section). Then replace the filter
holder in its initial position.
NOTE: If you do not want to use the grinder and decide to fill the
filter with normal ground coffee, press the GRIND OFF button, the
orange pilot light will come on.
Make sure the jug is placed correctly on the hotplate.
To switch on your appliance, press once the ON/OFF switch. The
red pilot light will come on and the coffee will start flowing after a
few seconds.
When you remove the jug from the appliance, a non-drip valve
will automatically operate to stop any drops of coffee dripping
onto the hotplate. Replacement of the jug automatically opens
the non-drip valve and allows remaining coffee to filter trough
into the jug.
Once the water tank is empty, we advise you to wait until the
brewing process is finished and the filter has run empty before
removing the jug.
You can switch off your appliance anytime simply by pressing the
ON/OFF switch until all pilot lights are off.
7
USK CCG 1 - 070323

Publicidad

Tabla de contenido
loading

Tabla de contenido