Support Bar Installation - Jacuzzi SAVANNAH-GP Instrucciones De Asamblea

SUPPORT BAR INSTALLATION

1-2. Install the 2 glass panel's brackets (O) and the support bar's anchor (M) onto the support bar (N & N1).
3. Insert the 2 glass panel's brackets (O) into the fixed glass panel (L) and the side panel (E). Ensure that the
plastic gaskets are in the brackets (O) as these protect the glass panels.
4. Mark the outline of the support bar's anchor (M).
5. Completely remove the support bar (N & N1). Place the support bar's anchor (M) back on it's wall mark,
mark the hole of it.
6. Drill a hole on the center marks with a ø1/4" (6mm) drill bit.
7-8. Insert the wall anchors (FF) using a rubber mallet. Fix the center fitting on the support bar's anchor (M)
using the screw (CC). Use screw (DD) when install without acrylic wall.
9-10. Install again the support bar (N & N1) onto the fixed glass panel (L), side panel (E) and support bar
anchor (M). Strongly tighten the bolts using 2.5mm Allen key.
1 2
&
N N1
&
N N1
M
O
3
4
6
5
ø1/4"
6mm
10
7 8
9
FF CC DD
15