Installation; Preparation - Dovre 2576CBSC Instrucciones De Instalacion Y Uso

The swing direction of the door can be altered. The
appliance is supplied with a left-handed door. For a
right-handed door a locking rod is needed (sold
separately). The instructions for changing the door
swing direction are provided with this locking rod.
The appliance is supplied with a connecting kit for
the outside air supply.
The appliance is not suitable for continuous use.
The insert fireplace has an integrated convection
system. This means that when installing the
appliance it is not necessary for a separate
convection space to be built and the use of air inlet
and outlet grates for convection is not necessary.
The space between the cast-iron fireplace and
steel convection box serves as convection
space. Surrounding air is drawn in at the
bottom of the appliance. The air is directed to
the fireplace where it is heated. The heated air
then leaves the front side of the convection
space through the air opening on the upper side
of the fireplace.
The appliance is equipped with two additional
connections in order to transport convection heat to
other areas.
The appliance is equipped with a built-in fan that
aids convection. The turning speed of the fan can
be adjusted using a speed control. The fan is
connected to the mains electric circuit; see
paragraph "Connecting fan to the mains".
The fan works thermostatically. That means
that the fan only starts to operate if the
Subject to change because of technical improvements
insert fireplace is sufficiently warm and the
fan switches off once the insert fireplace
has cooled sufficiently.
The fan can be removed so that the insert fireplace
does not have to be taken apart in the event of
maintenance or in the event that the fan has to be
replaced. See the chapter "Maintenance" for
instructions.
The connection is on the right-hand side of the
appliance.

Installation

Preparation

Please check the appliance for damage caused
during transport or any damage or defects
immediately after delivery.
If you detect damage caused during transport
or any other damage or defects, do not use the
appliance and notify the supplier.
Remove the removable parts (fire-resistant inner
plates, fire compartment, fire basket, ash removal
port and ash pan) from the appliance before you
start installing the appliance.
By removing removable parts, it is easier to
move the appliance and to avoid damage.
Note the location of those removable parts, so
that you have no difficulties in installing the
parts in the right place later on.
Removing the fireproof inner plates
Remove the fire-resistant inner plates; see the
following figure.
1. Open the door by turning the latch outward and
unlocking the door; see next figure.
7