Rear Panel - D-Link DES-1316 Guía Rápida De Instalación

half- and full- duplex transfer modes. These ports also support automatic MDI/MDIX
crossover detection to give true "plug and play" capability. You just need to plug-in the
network cable to the Switch directly, regardless of if the end node is a NIC (Network
Interface Card) or a switch and a hub
Note: When the port is set to "Forced Mode", Auto MDI/MDIX will be disabled.

Rear Panel

AC Power Connector:
This is a three-pronged connector that supports the power cord. Plug in the female connector of
the provided power cord into this connector, and the male into a power outlet. Supported input
voltages range from 100-240V AC at 50-60Hz.
Reset:
The Reset button is to reset all settings back to the factory defaults.
Note: Be sure that you record the settings of your device, or else all the settings w
ill be erased when pressing the "Reset" button.
Understanding LED Indicators
The front panel LEDs provide instant status feedback, and, help monitor and troubleshoot when
needed.
Reset Button
Rear panel of the Switch
5
AC Power Connector