Installation Procedure; Observe The Following When Installing; Installation On The Front Of The Cabinet Underneath The Appliance - Gaggenau Vario 400 Serie Instrucciones De Instalación

Installation Procedure

O bserve the following when installing:
I n s t a l l a t i o n P r o c e d u r e
When installing the control knobs in the work surface,
▯
seal the edges of the holes to make sure that they are
water-tight.
Depending on the distance between the control
▯
knobs, it may be necessary to break off the retaining
plate at the perforation.
When installing an individual control knob, use two
▯
screws to hold the retaining plate in place and prevent
it from rotating.
For stone countertops, use temperature-resistant two-
component adhesive (for metal to stone) to adhere the
retaining plate.
Remove the protective film on the back of the
▯
illuminated ring before installing.

Installation on the front of the cabinet underneath the appliance

Ensure that the control knobs are allocated to the
▯
correct burners during installation.
The marking at the side to identify the control knobs
▯
must always be on the left.
The two cable connectors on the control knob are
▯
identical.
After installing, check that all plug connections fit
▯
correctly.
After installing all the cables, secure them to the
▯
retaining plate by bending the tab down.
Follow the instructions in the manual for the type of
installation you require:
~ "Installation on the front of the cabinet
a
underneath the appliance" on page 5
~ "Installation in the countertop in front of
b
the appliance" on page 8
~ "Installation in the countertop next to the
c
appliance" on page 11
Installation Procedure
en-us
5