Trouble Shooting - Dexter 260MT3-QC.5 Manual De Instrucciones

7. Maintenance
containing ammonia. Do not use any of these to clean the saw.
d) Have an authorized service center examine and/or replace the worn carbon
brushes in the event of excessive parking.
e) Blades become dull even when cutting regular lumber, a sure sign of a dull
blade is the need to force the saw forward instead of guiding it while making a cut.
Take the blade to a service center for sharpening.
f) Keep the machine clean all the time.
g) If you discover any damage, consult the exploded drawing and parts list to
determine exactly which replacement part you need to order from our customer
service department.
h) Clean the housing only with a damp cloth. Do not use any solvents! Dry
thoroughly afterwards.
i) If the replacement of the supply cord is necessary, this has to be done by the
manufacturer or his agent in order to avoid a safety hazard.

8. Trouble Shooting

Problem
Product does not start
Product does not reach
full power
Unsatisfactory result
Possible cause
Not connected to power supply
Power cord or plug is defective
Other electrical defect to the
product
Carbun brush
Extension cord not suitable for
operation with this product
Power source(e.g.generator)has
too low voltage
Air vents are blocked
Blade is worn
Solution
Connect to power supply
Check by a specialist electrician
Check by a specialist electrician
replaced in pairs
Use a proper extension cord
Connect to another power source
Clean the air vents
Replace with new blade
FR
ES
PT
IT
EL
PL
UA
RO
EN
141