Setting The Time And Date Manually - ADE WS 1502 Instrucciones De Operación

‚ You can start the receiving process again manually,
‚ Wait until the base station automatically switches
‚ If reception is not possible at your location, you can

Setting the time and date manually

1. Press and hold the MODE button until the indicator for
2. Using the + and - buttons, set the desired time format
3. Press MODE to save the setting. The temperature unit
4. Proceed as previously described.
5. Press MODE each time to save the settings.
6. Press the + or - button to set the desired value.
7. Carry out the following settings:
Weather Station with Wireless Outdoor Sensor WS 1502/1503
FW Station.indb 57
see "Starting signal reception manually", or
to receiving mode again at a later point in time. The
reception is usually better at night.
set the time and date manually, see next chapter.
If there is more than approx. 20 seconds between
two pushes of a button, the setting process
automatically ends and you will have to repeat it.
the 12- and 24-hour time format blinks on the display.
("12 hr" or "24 hr").
blinks on the display.
− Temperature unit
− Air pressure unit
− Time zone in which you are located (for Germany,
choose 00)
57
21.09.2015 09:45:59