Care And Cleaning; Troubleshooting; Fcc Statement - Commercial Electric 17898 Guía De Uso Y Cuidado

Care and Cleaning

□
To clean the xture, disconnect the power by unplugging the adapter. Use a dry or slightly dampened, clean cloth to wipe the exterior
surface of the xture.
□ Do not use any cleaners with chemicals, harsh abrasives, or solvents. Use only a dry soft cloth to dust or wipe carefully.

Troubleshooting

Problem
The LED will not light.
The fuse blows or a circuit
breaker trips when the light is
turned on.

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
CAUTION:
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Possible Cause
The LED is burned out.
The power is off.
The power cord is not plugged in.
The connector has faulty connections. Check the connections of the connectors.
The circuit breaker is turned off.
A wire is exposed.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Solution
Discontinue use of the lamp.
Ensure the power supply is turned on.
Ensure the power cord is plugged into the outlet.
Ensure the circuit breaker is in the "ON" position.
Discontinue use of the lamp.
Unplug the unit from the
Contact a quali ed electrician or call the Customer Care
Service Team at 1-877-527-0313
Monday - Friday, 9 a.m. - 6 p.m., EST, Saturday.
9
Please contact 1-877-527-0313 for further assistance.
wall.
8 a.m. - 7 p.m., EST,
HOMEDEPOT.COM