Environmental Specifications; Fitting The Feet - ifi 750 Manual Del Usuario

GB
The display unit should be positioned in such a way
that it is perfectly level.
You should also make sure, during installation, that:
- there is sufficient air circulation around the
Panorama but not so much as to constitute a
draught;
- the Panorama is not placed near sources of hot air;
- it is not exposed to direct sunlight;
- the grilles designed to let air pass through for the
cooling of the condenser are not blocked;
- any air conditioning or heating inside the premises
is not directed at the Panorama.
NOTE:
The instructions listed above must be observed in order to prevent appliance malfunctions
which are not covered by the guarantee.

2.4 ENVIRONMENTAL SPECIFICATIONS

CAUTION!
The display unit can operate at a
at 65% relative humidity, as long as the
equipment regularly undergoes scheduled
maintenance.

2.5 FITTING THE FEET

CAUTION - RISK OF CRUSHING!
Procedure to be performed by 2/3 people.
While the body (B) is lifted, use a box wrench
wooden sleepers.
CAUTION!
This procedure must be performed with
great care and safety precautions should
be taken.
Replace the feet using the locknut and tighten them
halfway (they will be adjusted and tightened in
subsequent steps).
Adjust the feet to make sure the body (B) is level and
at the correct height.
Once it is level, tighten the locknuts of the feet.
If the Panorama must be ducted, wait until they have
32
Fig.8
Fig.9
2
1
3
Fig.10
B