Operation; General Information; Machine Settings And Programs; Maintenance - CombiSteel DROP-IN Serie Manual De Instrucciones

EN
The DE-CH120 version has also space for an additional ON/ OFF switch (not supplied) in case a
foodshield is installed on it.

4 OPERATION

4.1 GENERAL INFORMATION

The electrical connections must only be completed by a qualified electrician.
The appliance is turned on by pressing the start-up switch located on the front part of the
controls. Said switch will light up.
A power supply other than the type specified may seriously damage the system. The controller
must be used only in the manner described in the documentation related to the product, to
reach the expected results in relation with the final installation.
Electric circuit is provided with all the safety devices required to guarantee correct operation
and the complete safety of the user.
Machine maintenance operations must only be carried out by specialized technicians provided
with suitable personal protection equipment.

4.2 MACHINE SETTINGS AND PROGRAMS

The light intensity and color can be change by a remote controller supplied with the machine.

5 MAINTENANCE

5.1 GENERAL SAFETY RULES

Remove the outside plastic and any remaining adhesive covering the steel.
Clean carefully before using by following the specific instructions detailed later in this manual.
Before carrying out any operation on the machine, always consult this manual which gives the
correct procedures and contains valuable information on safety.
Keeping the well clean and empty during periods of no service, allows a better conservation of
the appliance.
Drain valve must keep closed only when is not possible the installation of a drain outlet.
During ice melting, keep the water lower than the led illumination level to avoid damaging the
electric components.

5.2 MACHINE CLEANING AND MAINTENANCE ROUTINE

Any technical maintenance must be carried out by your distributor's technical assistance
service.
CLEANING ADVICES
• Always ensure that the appliance is disconnected from the main power supply before
cleaning. Do not splash water on the electric components.
• It is possible extraction of the well with the leds simply unscrewing the IP68 connector
placed next to the wire exit hole.
• To clean the stainless steel, use a sponge or cloth, tepid water and neutral soap. Do not
use abrasive products, solvents, metal cleaning liquids or undiluted detergents. Dry with
a cloth afterwards.
Instruction Manual
[13]