SSS Siedle BCVU 850-1-0 E Informacion De Producto página 7

Demontage
Die Demontage erfolgt in umge­
kehrter Reihenfolge. (Bild 10-12)
Technische Daten
Kontaktart: Schließer 24 V, 2 A
Schutzart: IP 54, IK 8
Umgebungstemperatur:
–20 °C bis +40 °C
Abmessungen Frontplatte (mm)
B x H x T: 110 x 273 x 1
Abmessungen Gehäuse (mm)
B x H x T: 85 x 253 x 48
English
Application
Siedle Compact video door station
flush mounting in bus technology,
for installation in the In­Home bus.
With the functions calling, speech,
vision and door release.
Performance features:
• Integrated camera with automatic
day/night switchover, LED lighting
and 2­stage heating
• Integrated door loudspeaker
• Adjustable voice volume
• Number of integrated call but­
tons: 1, 2
• Acoustic button acknowledgement
can be activated
• Backlit nameplates exchangeable
from the front
• For flush mounting with brushed
stainless steel panel
Electrical voltage
Mounting, installation and servicing
work on electrical devices may only
be performed by a suitably qualified
electrician.
Electrostatic charging
As a result of electrostatic charging,
direct contact with the circuit board
can result in destruction of the
device. Direct contact with the circuit
board must therefore be avoided.
1 In the case of video systems, the
following mounting situation must
be avoided at all costs:
• direct backlight
• direct sunlight
• very bright image backgrounds
• highly reflective walls opposite the
camera
• lamps or direct light sources
Scope of supply
• BCVU 850-...-0
• Flush­mount housing
• This product information
Terminal assignment
TaK, TbK In­Home bus camera
branch
Tö (c) Relay contact door release
b, c 12 V AC supply for
camera heating
Mounting
2 Remove the housing front. To do
so, loosen the screw on the under­
side of the housing. Open the base
plate upwards.
3 Recommended mounting height
appr. 1.50 m/4.9 ft to centre device.
4 Remove the cardboard plaster
protector from the flush­mount
housing, break out the cable break­
through from the housing and
thread in the cable. Reinforce the
flush­mount housing using the card­
board plaster protector
5 and grout the flush­mount
housing flush. The plaster protector
must be inserted into the housing
to prevent deformation. It must not,
under any circumstances, protrude
from the wall and may be grouted
max. 14 mm in the wall, as other­
wise the fixing screws for the front
panel will be too short.
6 The cores may only be laid in the
admissible installation space.
7 Install in accordance with the
wiring diagram.
Circuit diagram note
a) The camera branch and monitor
branch must be laid separately and
must not be located in the same
cable. This can result in disturbance
to the picture composition.
Important!
Before using the door release
terminal(s) (door release relay con­
tact), observe the "Door release
actuation" information in the
System Manual In-Home bus: Audio
or Video.
7