Wayne Dalton Prodrive 3220C Instrucciones De Instalación Y Manual Del Propietario página 17

14
Tools Needed:
WARNING
None
TO REDUCE THE RISK OF ELECTRICAL
SHOCK, DO NOT CHANGE THE POWER
CORD IN ANYWAY.
IMPORTANT: THE OPENER MUST BE
CONNECTED TO A PROPERLY GROUNDED 3
PRONG, 120 VOLT OUTLET.
The opener can be permanently wired. To
permanently wire the unit, see permanent
wiring option on page 20.
Plug the power cord into the closest
grounding type receptacle. Excess power
cord length must be routed and contained
safely away from any moving parts.
As soon as power is applied to the opener,
the light on the opener will blink once to
indicate a successful self-check of the
controls.
15
Tools Needed: Slide the trolley until it snaps onto the latch
assembly.
None
Attach warning label to the red release cord.
Thread the red release cord through the pull
knob so knot is inside pull knob. Tie a double
knot at the end of the red release cord to
secure pull knob.
NOTE: Pull knob should hang 6 feet above
floor. Ensure that the rope and handle clear
the tops of all vehicles to avoid
entanglement.
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
Connecting Opener
To Outlet
Connecting Trolley
To Latch Assembly
Outlet
Power Cord
Latch Assembly
Use a Double Knot
To Secure The Red
Pull Knob
Trolley
Upper Door Arm
Trolley
Release Cord
Pull Knob
Tag
11