Wayne Dalton Prodrive 3220C Instrucciones De Instalación Y Manual Del Propietario página 36

NOTE: This step can only be done on automobiles equipped with the
HomeLink ® System.
NOTE: Programming HomeLink
Transmitter that is programmed to the opener (the wallstation and
transmitter(s) supplied with the opener, come pre-programmed from
the factory). Any additional wallstation(s) or transmitter(s) will need to
be programmed to the opener, see page 33.
IMPORTANT: Use the programming instructions provided with your
vehicle first. Follow these instructions if the HomeLink
learn the transmitter, when using the vehicle's instructions.
NOTE: If Primary Programming does not work then use the Alternate
Procedure on next page.
NOTE: Vehicle may need to be in accessory position when
programming. Check car owner's manual.
®
NOTE: HomeLink is a registered trademark of Johnson Controls.
30
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
Primary Programming for HomeLink
®
requires a Wayne-Dalton
®
unit does not
®
to the Prodrive
Programming/Training HomeLink
WARNING
GARAGE DOOR MAY OPERATE DURING PROGRAMMING. TO AVOID
POSSIBLE SEVERE OR FATAL INJURY, PLACE THE EMERGENCY
DISCONNECT HANDLE IN THE MANUAL OPERATED POSITION.
1. Pull the manual disconnect to put the opener in the disengaged
position.
®
2. Verify the HomeLink unit has an empty channel press the desired
®
HomeLink button and observe the indicator light if it flashes slowly,
the channel is empty and ready for programming. If pressing the
desired channel/button causes the indicator light to blink rapidly, or
come on without blinking this channel is already programmed. You
either need to choose a different channel/button on the HomeLink
perform Step 3 below.
3. OPTIONAL – To completely clear all channels on the HomeLink
unit, press and hold the two outside buttons on the HomeLink
®
until the HomeLink indicator light begins to flash rapidly (approx. 20
seconds), then release both buttons. (Do not perform this step to train
additional hand-held transmitters.) NOTE: This operation erases all
previously learned transmitters and you will need to re-teach any other
transmitters to your HomeLink ®
4. Hold the end of the Wayne-Dalton hand-held transmitter
approximately 1 to 3 inches away from the HomeLink
the HomeLink ® indicator light in view.
5. Simultaneously press and hold the Wayne Dalton transmitter large
button and desired button on the HomeLink
hold both buttons. In less than 10 seconds the LED on the HomeLink
module will either go solid or give a single quick flash, release both
buttons when either occur.
NOTE: If this procedure is unsuccessful perform Alternate procedure.
®
Teaching HomeLink to the opener
6. Press and release the program switch on the opener. The red
program status light on the opener and light will turn on and remain lit
for one minute, indicating that it is ready to learn.
7. Press the HomeLink ® button used in Step 5 above for 1 to 3
seconds. The program status light and convenience light on the opener
will turn on and off three times indicating a successful learn.
®
8. Press the HomeLink button once more to operate the door. The
opener will activate and the trolley will travel towards open, the next
activation will cause the trolley to travel to the closed position and
reengage, subsequent operations will move the door.
®
®
Unit
®
unit.
®
surface keeping
®
module, continue to
® , or
®
unit
®