Control Locations; Basic Operation; Batteries; Power On/Off/Volume - Eton G1000A Manual De Operación

3

CONTROL LOCATIONS

1. Antenna

2. Stand (rear)
3. Display
4. Tune LED
5. FM ST. LED
6. Tuning Knob
7. Hour
8. Minute
9. Light
10. Sleep
11. Power On/Off
1
2
21
20
19
18
16
17 15
6
12. Band Indicator
13. Band Selector
14. Time Set
15. Alarm Set
16. Alarm On/Off
17. Battery Compartment (rear)
18. Hand Strap
19. DC Jack
20. Earphone Jack
21. Volume Knob
3
4
5
6
7
8
9
10
11
13 12
14
4 BASIC OPERATIONS

1. BATTERIES

Remove the battery compartment cover by pushing it in the
direction of the arrow. Install two 'AA' batteries according to the
polarity symbols (+ and -) marked next to the compartment.
For easy removal, place the batteries on top of the lift-out ribbon.

2. POWER ON/OFF/VOLUME

Turn the radio on by switching the power on/off switch (11).
Use the volume knob (21) to adjust the volume.

3. FM RADIO

Select the FM band by using the band selector switch (13).
Use the tuning knob (6) to tune the radio to the desired frequency.
When a strong signal is found, the TUNE indicator will light.
If you are using an earphone to listen to FM stereo, the
FM ST. LED (5) will light. Note that the frequency of the station
appears in the display (3).

4. AM/SW1-8 RADIO

Select the desired band, AM or SW 1-8, by using the band selector
switch (13). Turn the tuning knob (6) to the desired frequency \
which appears in the display (3) or just tune around and listen for
stations. Note that MW appears in the display when AM is
seleced. That's because the AM band is called MW (for medium
wave) in some parts of the world. SW appears in the display when
SW 1-8 is selected.
5. ANTENNA
A. For AM (MW) the radio uses an internal, directional, ferrite bar
antenna. Rotate the radio for best reception.
B. For FM/SW, fully extend the telescopic antenna (1). For FM,
rotate it for best reception.
G1000A OPERATION MANUAL
7