Installing The Led Assembly And Glass Shade - Hinkley 52 VENTUS Manual De Instrucciones

INSTALLING THE LED ASSEMBLY AND GLASS SHADE

NOTE: Be sure the power is off before installing.
Remove one of the three screws on the mounting plate
1
located on the fan motor. Loosen the other 2 screws. (Do not
remove) (Fig. 2)
While holding the LED assembly under your fan, make the
2
polarized plug connections: (Fig. 2)
- Red to white
- Black to black
Tuck connections neatly into mounting plate. Place the key
3
holes on the LED assembly over the 2 screws previously
loosened, turn the LED assembly until it locks in place at the
narrow section of the key holes. Secure by tightening the 2
screws previously loosened and the one previously removed.
4 Raise the glass shade against the LED assembly and turn
clockwise until snug, DO NOT OVERTIGHTEN.
5
Restore power and your LED assembly is ready for operation.
12 | hinkley.com
Wire connectors
Light
assembly
Fig. 2
5
Screws