Publicidad
Idiomas disponibles
Idiomas disponibles
5. Fixing the sink to the worktop.
After applying the resin, fix the clamps or jacks to tighten
the sink to the worktop. They must be tightened until as
much resin as possible is expelled, since any remaining
resin could be visible.
6. Cleaning the parts to be bonded.
Clean a 10cm strip around the top of the outside wall of
the sink and the worktop with alcohol or solvent.
7. Filling the gap between pieces.
Fill the gap between the sink and the worktop with resin.
If this gap is not filled, the worktop could break around
the edge of the gap. A fibreglass mesh must also be
placed all around the perimeter to reinforce the joint
between the sink and the worktop. ATTENTION: Do not
cover the overflow hole with the fibreglass mesh.
Area to be cleaned
Fibreglass mesh
Installation manual Integrity by Silestone®
2
8. Reinforcing the worktop.
In order to prevent breakage of the worktop and to
reinforce it, fix a wooden baton to the wall, the distance
between the units, on the underside of the worktop.
9. Bevelling.
Once the sink is bonded to the worktop, you must polish
the remaining edge until the entire outline is bevelled.
Finish
Countertop
Sink
10. Reinforcement anchorage kits
(see the last two pages of this manual).
Countertop
Sink
Reinforcement block
17
Publicidad
