Prepare The Site - Kohler K-1843 Manual Del Usario

Step 1
Install plastic sheeting.

3. Prepare the Site

Step 1
Wrap and staple water barrier plastic sheeting into the stud pocket.
Place and staple water barrier plastic sheeting over the remaining shower area.
If applicable, install the shower basin at this time.
Step 2
Determine the desired seat height from the finished floor. A seat height of 18" (45.7 cm) from the
finished floor is recommended.
Verify that this height will not compromise the watertight membrane that may be present in the
floor when fasteners are installed to the bottom flange of the seat. Adjust the height, if necessary.
Position and level the seat unit on the studs with the seat at the desired height. Mark the corners of
the seat unit on the studs, then set the seat aside.
Step 3
IMPORTANT! Select wall material that is water resistant (such as cement board) and meets local building
codes.
IMPORTANT! A flush transition must exist between the wall material and the attachment flange.
Verify the wall material equals the thickness of the attachment flange, which is 1/4" (6 mm). This
will ensure a flush transition. If a flush transition does not exist, either the studs or attachment
flange must be shimmed before installing the wall material.
Install wall material around the stud pocket leaving an opening 62" (157.5 cm) in height and 17-1/2"
(44.5 cm) width for the seat unit.
Kohler Co.
Step 2
Level, then
mark each
corner.
18" (45.7 cm)
Recommended
Seat Height
Level, then mark
each corner.
Step 3
17-1/2" (44.5 cm)
5
Attachment
Flange
Flush
Transition
Install wall
material.
1071449-2-B