Electrical Safety; Personal Safety - Cramer 82PS Manual Del Usuario

•
Keep children and bystanders away while operating a power tool.
Distractions can cause you to lose control.

Electrical safety

•
Avoid body contact with earthed or grounded surfaces, such as pipes,
radiators, ranges and refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
•
Do not expose power tools to rain or wet conditions. Water entering a
power tool will increase the risk of electric shock. Please note that rain, fog
and other humidity can vary in intensity and the equipment can not be used
in extreme conditions. Keep batteries away from saline environment and
contaminated liquids. After use, the battery and the device are to be dried.

Personal safety

•
Stay alert, watch what you are doing and use common sense when
operating a power tool. Do not use a power tool while you are tired or
under the influence of drugs, alcohol or medication. A lapse of attention
while operating power tools may result in serious personal injury.
•
Use personal protective equipment. Always wear eye protection.
Protective equipment such as dust mask, non-skid safety shoes, hard hat
or hearing protection used appropriately will reduce personal injuries.
•
Prevent unintentional starting. Ensure the switch is in the off position
before connecting to power source and/or battery pack and when picking
up or carrying the tool. Carrying power tools with your finger on the switch or
energizing power tools that have the switch on invites accidents.
•
Remove any adjusting key or wrench before turning the power tool
on. A wrench or a key left attached to a rotating part of the power tool may
result in personal injury.
•
Do not over-reach. Keep proper footing and balance at all times. This
enables better control of the power tool in unexpected situations.
• Dress properly. Do not wear loose clothing or jewellery. Keep your hair,
clothing and gloves away from moving parts. Loose clothes, jewellery
or long hair can be caught in moving parts.
•
If devices are provided for the connection of dust extraction and
collection facilities, ensure these are connected and properly used. Use
of dust collection can reduce dust-related hazards.
Power tool use and care
•
Do not force the power tool. Use the power tool for the application.
The correct power tool will do the job better and safer at the rate for which
it was designed.
•
Do not use the power tool if the switch does not turn it on and off.
Any power tool that cannot be controlled with the switch is dangerous and
must be repaired.
•
Disconnect the plug from the power source and/or the battery pack
from the power tool before making any adjustments, changing
accessories, or storing power tools. Such preventive safety measures
reduce the risk of starting the power tool accidentally.
•
Store idle power tools out of the reach of children and do not allow
persons unfamiliar with the power tool or these instructions to operate
the power tool. Power tools are dangerous in the hands of untrained users.
•
Maintain power tools. Check for misalignment or binding of moving
parts, breakage of parts and any other condition that may affect the
power tool's operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly maintained power tools.
• Keep cutting tools sharp and clean. Properly maintained cutting tools
with sharp cutting edges are less likely to bind and are easier to control.
•
Use the power tool, accessories and tool bits etc.in accordance with
these instructions, taking into account the working conditions and the
work to be performed. Use of the power tool for operations different from
those intended could result in a hazardous situation.
•
When not in use, store the machine out of the reach of children. Make
sure to store the product indoors, in a dry place.
Battery tool use and care
• Recharge only with the charger specified by the manufacturer. A
charger that is suitable for one type of battery pack may create a risk of fire
when used with another battery pack.
•
Use power tools only with specifically designated battery packs. Use
of any other battery packs may create a risk of injury and fire.
•
When battery pack is not in use, keep it away from other metal
objects like paper clips, coins, keys, nails, screws, or other small metal
objects that can make a connection from one terminal to another.
EN
3
cramer.eu