Cleaning The Chain; Storing The Product; Troubleshooting - Cramer 82PS Manual Del Usuario

• To avoid overheating and damage to the motor or the battery, always keep
EN
the cooling air vents clean and free of debris.

Cleaning the chain

Remove any traces of sawdust or oil deposits from the chain every time it is
used.
If there is excessive dirt or resin build-up, disassemble the chain and place it in a
container with a specific cleanser for a few hours. Then rinse it with clean water and
treat it with a suitable anticorrosive spray, before reassembling on the machine.
STORAGE

Storing the product

When the machine is to be stored away:
1 Remove the battery from its housing and recharge it;
2 Mount the bar cover.
3 Wait until the motor is sufficiently cold;
4 Clean.
5 Check there are no loose or damaged components. If necessary, replace
the damaged components and tighten any screws and loose bolts or
contact the authorised service centre.
6 Store the machine:
• – review the ambient temperature chart for information on storage
temperature.
•
– in a dry place
•
– protected from inclement weather
• – in a place where children cannot get to it
• – making sure that keys or tools used for maintenance are removed.
8
cramer.eu

Troubleshooting

PROBLEM PROBABLE CAUSE
The poles are not assembled
correctly.
No electrical contact
between the pole saw and
battery.
Pole saw
The battery pack is
fails to
depleted.
operate.
The lock-off lever and
trigger are not depressed
simultaneously.
The battery and power tool
is too hot or too cold.
No oil in the oil tank.
The discharge port is blocked
by debris.
Inlet opening in inner oil tank
is blocked by debris.
Bar and
chain
running
The sprocket is stuck and
hot and
clogged with debris.
smoking.
Chain tension for
overtightened or loose
condition.
POSSIBLE SOLUTION *
Reassemble the poles according
to the instructions.
To secure the battery, make
sure the latches on the battery
compartment snap into place.
Charge the battery pack.
Press down the lock-off lever and
hold it, then depress the trigger to
turn on the pole saw.
Refer to the battery and charger
maintenance part in the manual.
Refill oil into the oil tank.
Refer to the manual to remove
the bar and clean out the debris.
Clean the oil tank, and refill with
clean bar and chain lubricant.
Clean the sprocket and refill with
clean bar and chain lubricant.
Refer to Re-tensioning the saw
chain in the manual.