Cramer 82PS Manual Del Usuario página 6

• Hold the lip of the bar up and tighten the lock nut securely.
EN
• Chain is correctly tensioned when there is no slack on the underside of the
bar, the chain is snug, but it can be turned by hand without binding.
•
Tighten the lock nut.
NOTE: If the chain is too tight, it will not rotate. Loosen the chain cover lock nut
slightly and turn the chain adjustment screw 1/4 turn counterclockwise. Lift the
tip of the guide bar up and retighten the chain cover lock nut. Ensure that the
chain will rotate without binding.
To Install/ Remove the Battery
To Install
(see Figure 5)
1 Align the tongue of the battery pack with the cavity.
2 Grasp the pole saw firmly.
3 Push the battery pack into the handle until the latch locks into place.
4 It should slide into position and "click" .
To Remove
(see Figure 5)
1 Press the latch button on the battery pack down and hold.
2 Grasp the pole saw firmly, and pull the battery pack out of the handle.
Operation
Starting operation
(see Figure 6)
1 Press the on/off button.
2 Pull the safety lock button backward using your thumb and at the same
time squeeze the trigger.
3 Release the safety lock button.
Stopping operation
(see Figure 6)
1 Release the trigger.
2 Press the on/off button to turn off the machine.
6
cramer.eu
Adding bar and chain lubricant
Use Bar and Chain Lubricant. It is designed for chains and chain oilers, and is
formulated to perform over a wide temperature range with no dilution required.
NOTE: Pole saw comes from the factory with no bar and chain lubricant added.
Level should also be checked after every 20 minutes of use and refilled as needed.
1 Unscrew and remove the cap from the oil tank.
2 Pour oil in the tank and monitor the level on the indicator.
3 Make sure no impurities penetrate the oil tank when filling.
4 Screw on the oil cap and tighten it.
NOTE: Do not use dirty, used or otherwise contaminated oils. Damage may occur
to the bar or chain.
NOTE: It is normal for oil to seep from the saw when not in use. To prevent
seepage, empty the oil tank after each use then run for one minute. When storing
the unit for a long period of time (three months or longer) be sure the chain is
lightly lubricated; this will prevent rust on the chain and bar sprocket.
Preparation for cutting
•
Wear non-slip gloves for maximum grip and protection.
•
Maintain a proper grip on the unit whenever the motor is running. Use your
right hand to firmly grip the rear handle while your left hand has a firm grip
on the pole shaft.
•
Hold unit firmly with both hands. Always keep your left hand on the pole
shaft and your right hand on the rear handle, so your body is to the left of
the chain line. Never use a left-handed (cross-handed) grip, or any stance
that places your body or arm across the chain line.
•
Never stand directly under the limb you are cutting.
• Be certain the collars are fully tightened before operating equipment; check
them periodically for tightness during use to avoid serious injury.
Work techniques
(see Figure 8)
Delimbing a tree
(see Figure 7)