Dull chain.
The chain
does not
Chain on backwards.
cut.
Motor stops after about 3
seconds.
When using the pole saw
under load, it stops.
Battery is not charged.
Motor
running,
but cutting
abnormal
Lack of bar and chain
lubricant can cause
increased friction. Chain
needs to be properly
maintained.
Incorrect battery storage
temperature.
* If the fault is not solved, you must go to your distributor and/or nearest Authorized
Technical Service.
Sharpen or replace the chain.
Refer to Replacing the Bar and
Chain assembly earlier in this
manual.
Recharge the battery.
Release trigger. Restart the pole
saw. Do not force the pole saw.
Refer to the manual for proper
use.
Charge the battery. Refer to the
battery and charger manual for
correct charging procedures.
Make sure the pole saw always
has bar and chain lubricant.
Allow the battery pack to cool until
the temperature drops to room
temperature.
Technical Data
PROPERTY
Type
No Load Speed
Guide bar length
Chain type
Bar type
Battery pack
Charger
Chain oil capacity
Weight without battery pack
Emission sound pressure level
LpA
Sound power level LwA
Guaranteed sound power level
LwA(G)
Vibration total value ah
VALUE
Cordless, battery-operated
18m/s±10%
250 mm
25AP058X
100SDAA041
82V220G/82V430G/82V220/82V430
82C1G/82C2/82C6
150 ml
5.1 kg
83 dB(A), K
: 3 dB(A)
PA
L
= 95.7 dB(A)
WA
L
= 99 dB(A)
WA
< 2.5 m/s
, k= 1.5 m/s
2
2
9
cramer.eu
EN