Automated Learning Process/Activating Code; Important; Remote Control And Fan Operation - Harbor Breeze E-CM54RBZ5CRCI Manual Del Usuario

AUTOMATED LEARNING PROCESS/ACTIVATING CODE

CAUTION: The remote control transmitter (W) can be programmed
to multiple receivers or fans. If this is not desired, turn wall switch
off to any other programmable receiver or fan.
1. Remove battery cover from back side of remote control
transmitter (W).
2. Set the code on the remote control transmitter (W) by sliding
code switches 1 through 4 to your choice of up or down position.
(Factory setting is all up. Do not use this position.) Use a small
screwdriver or ballpoint pen to slide firmly up or down. [Fig. 1]
3. Locate dimmer switch to the right of the code switches labeled
with a "D" and an "X". [Fig. 1] Set dimmer switch to the "ON" (D)
position only if using incandescent bulbs. Set dimmer switch to
"OFF" (X) position if using compact fluorescent bulbs.
NOTE: Most compact fluorescent bulbs are not compatible for use
with dimmer controls.
4. Install the 9-volt battery (Z) provided.
5. Restore electrical power. Within 30 seconds of restoring
electrical power, press the "FAN/OFF" button on the remote control
transmitter (W) for 5 seconds or until lower light blinks twice. Test
the light and fan functions to confirm the learning process is
complete. [Fig. 2]
6. Replace battery cover on remote control transmitter (W). [Fig. 1]
IMPORTANT: To prevent damage to remote control transmitter
(W), remove the battery (Z) if not used for long periods. Store the
remote control transmitter (W) away from excess heat or humidity.
This remote control transmitter (W) is equipped with 16 code
combinations to prevent possible interference from or to other
remote units such as garage door openers, car alarms or security
systems. If you find that your fan and light kit go on and off without
using your remote control, simply change the combination code in
your remote control. If you do change the combination code turn
power off and repeat Steps 5 and 6 above.
REMOTE CONTROL AND FAN OPERATION (continued on next page)
1. Operation buttons on the panel of the remote control transmitter (W)
[Fig. 1]:
HI button
MED button
LOW button
FAN/OFF button
TOP LIGHT button
BTM LIGHT button
The light function is controlled by pressing the TOP LIGHT and/or BTM
LIGHT button. Hold either button down to increase or decrease light. Tap
either button quickly to turn light off or on. If you press either button in
excess of 0.7 seconds it becomes a dimmer. The light varies cyclically in
0.8 seconds. The light buttons have an auto resume function which
keeps the light at the same brightness as the last time it was turned off.
IMPORTANT: Turn fan off at wall switch and let blades (J) come to a
complete stop before manually activating the reverse switch.
for fan HIGH speed
for fan MEDIUM speed
for fan LOW speed
for turning fan OFF
for light BRIGHTNESS and OFF, upper light
for light BRIGHTNESS and OFF, lower light
9
Code
Switches
Z
W
Battery
Cover
Fig. 1
W
Fig. 2
W
Fig. 1
Pen
Dimmer
Switch