Caring For Filters; Cleaning Metal Grease Filters - Faber LEVN24SS300 Instrucciones De Instalación Información De Uso Y Cuidado

CARING FOR FILTERS

CLEANING METAL GREASE FILTERS

The metal grease filtaers can be cleaned in hot detergent solution or washed
in the dishwasher.
They should be cleaned every 2 months use, or more frequently if use is
particularly heavy.
Remove the filter, pushing the lever towards
1
the back of the unit while pulling downward.
2
Wash the filter without bending it. Leave it to
dry thoroughly before replacing. If the surface
of the filter changes color over time, efficiency
will not be affected.
3
To replace the filter, push the filter up into po-
sition while holding the lever back, then release
lever to lock in place.
NOTES:
• Cleaning in a dishwasher may dull the finish of the metal grease filters.
• Ensure that the filters are completely dry before installing them back into
the Range Hood.
CLEANING EXTERIOR SURFACES
Please note, abrasives and scouring agents can scratch range hood finishes
and should not be used to clean finished surfaces.
Stainless Steel finish cleaning instructions:
Clean exterior surfaces with a commercially available stainless steel cleaner.
28
nectors.
• Lock in position by tightening the screws Vf from
underneath the hood.
• The Hood can be installed directly on the
• Open the suction panel by turning the specific knob.
underside of the wall unit (Minimum 650 mm
• Disconnect the panel from the hood canopy by sliding the
from the Cooker Hob).
fixing pin lever.
• Create an opening in the bottom of the wall unit,
as shown.
• Insert the hood until the side supports snap into
place.
• Remove grease filters.
• Fasten using the 10 screws 12a provided.
• Lock in position by tightening the screws Vf from
underneath the hood.
• Screw the Frame into place
• Open the suction panel by turning the specific knob.
using the 6 screws 12f, re-
• Disconnect the panel from the hood canopy by sliding th
connect the wires to the
fixing pin lever.
Commands and Light, re-
place the metal grease filter
and the Panel.
• Remove grease filters.
• Screw the Frame into place
EN
using the 6 screws 12f, re-
connect the wires to the
Commands and Light, re-
place the metal grease filter
and the Panel.
EN