Cleaning Metal Grease Filters; Lighting Unit - Faber Nova PRO Instrucciones De Instalación

Cleaning metal grease filters
The filters must be cleaned every 2 months of operation,
or more frequently for particularly heavy usage, and
can be washed in a dishwasher.The metal grease filters
should be cleaned frequently in hot detergent solution or
washed in the dishwasher. Stainless steel cleaner should
be used on stainless rangehoods. Abrasives and scouring
agents can scratch stainless steel finishes and should not
be used to clean finished surface. Remove all water or
any other liquid from washing before re-installing filters.
• Remove the filters one at a time, supporting them
with one hand and turning the safety knobs (pull
and turn).
• Wash the filters, taking care not to bend them.
Allow them to dry before refitting.
• Replace them and fix them using the safety knobs
provided (pull and turn).
Replacing Activated Charcoal Filter
The Activated Charcoal Filters are not washable
and cannot be regenerated, and should be replaced
approximately every 4 months of operation, or more
frequently with heavy usage.
• Remove the charcoal filter by rotating it clockwise (
backwards) until it unlocks from the motor housing
and pull off sideways.
• To re-insert each charcoal filter, place up against the
side of the blower and push it inward. Then turn the
charcoal filter clockwise (forward) until it fits into place.
"When used in recirculation mode, to Reduce the
Risk of Fire and Shock use only conversion kit
Model FILTER 1"

Lighting unit

• Remove the snap-on lamp cover by levering it from
under the metal ring, supporting it with one hand.
• Replace the lamp with a new one of the same type,
making sure that you insert the two pins properly into
the housings on the lamp holder.
• Replace the snap-on lamp cover.
18
B
5
W