How To Operate Ne-2153-2/Ne-1653; Manual Single Stage Heating - Panasonic NE-2153-2 Manual De Instrucciones

How to Operate NE-2153-2/NE-1653

POWER LEVEL SELECTOR PAD
Each time the pad is pressed, the Power Level switches as the illustration below.
P10 P9
P2 P1
HIGH
MEDIUM
HIGH
MEDIUM
*IEC Test Procedure
A. Manual Single Stage Heating
(Continued on next page.)
P8 P7
P0 PU1
P10: 1600 W* (NE-1653)
2100 W* (NE-2153)
P9: 90%
P8: 80%
P7: 70%
P6: 60%
P5: 50%
P4: 40%
1. Make sure the oven is plugged into a properly earthed electrical outlet.
2. Open the door.
The oven lamp will turn on. "0" will appear in the Digital Display Window.
3. Put the food into a suitable container, place it in the centre of the oven and then close
the door securely.
The oven lamp will turn off.
Note: While "0" appears, operation is available. 1 minute after the door is closed,
"0" will disappear.
4. Select the desired Power Level by touching Power Level Selector Pad.
The selected Power Level will be displayed in the Digital Display Window and the
single stage heating indicator "1" will start to blink.
[Example]: Touch Power Level Selector Pad once for HIGH power.
Note: Each time Power Level Selector Pad is touched, the Power Level switches as
the above Power Level Selector illustrates.
5. Set the desired heating time by touching the appropriate Number Pads.
Note: The maximum set time for "DEFROST" and "P0" is 30 minutes, and
15 minutes for all others.
[Example]: Touch Number Pads "2", "0" and "0" for 2 minutes.
6. Touch Start Pad.
A. The oven lamp will turn on.
B. Heating will start.
C. During operation, the indicator appears from the left.
D. The heating time on digital display will count down.
7. When all time expires, the end of cycle beep tone will sound and all heating will stop.
The oven lamp will turn off. The display will blink "0000" until the door is opened.
1 minute later cooling fan will stop.
P6 P5
PU2 PL1
LOW
DEFROST
OFF
HEAT FROM
TOP DOWN
HEAT FROM
BOTTOM UP
- 15 -
P4 P3
PL2 P10 again.
P3: 30%
P2: 25%
P1: 340 W
P0: 0%
PU1: 50%
PU2: 25%
PL1: 50%
PL2: 25%