Remote Control - Best CC34IQSB Manual Del Usuario

REMOTE CONTROL

The remote control is linked to the hood at the factory.
If, for some reason, the link is lost - follow the directions below:
To Link Remote Control to Hood
1. Turn off hood motor and hood lights.
2. Press and
control Indicator Light turns on (Fig.3). Release
button to confirm the linking. At this point the remote control Indicator Light starts
flashing to confirm the link is active.
3. Within 3 seconds - press ƒ (P2) on the hood control (Fig. 4). The LED ring will light up for
approximately 10 seconds to confim that the linking process was successful.
Remote Control Functions (Fig.3)
Delay - Off
Blower Speed Decrease and Off
Blower Speed Increase and On
Light
Press (Delay) and
IMPORTANT: holding
will cause the link between the remote and hood to be lost.
CAUTION RISK OF EXPLOSION IF BATTERY IS
REPLACED BY AN INCORRECT TYPE. DISPOSE
OF USED BATTERY TO THE INSTRUCTION.
Battery disposal
When the batteries need to be replaced, dispose of them only and exclusively in the numerous
readily available special waste bins, especially in shops selling electronic consumer goods.
Observance of the regulations on differentiated waste collection, in particular, proper disposal of
used batteries, contributes to preventing possible negative effects on the environment and health.
buttons on the remote simultaneaously for 5 seconds, until the remote
INDICATOR
LIGHT
FIG. 3
(Light) together to Reset Filter Alarm.
(Delay) for more than 3 seconds
and
HOOD CONTROL
See "Controls" section on previous page
for more information on each function.
- 5 -
buttons. Press and release
L1
LED
RING
FIG. 4