K2 Pumps ASP00001K El Manual Del Propietario página 3

MATERIALS REQUIRED (NOT INCLUDED)
NOTE:
Parts shown below not to scale.
SPECIFICATIONS
Liquid temp. range
INSTALLATION
1. NOTE: Install the emergency sump pump when the primary sump
pump isn't needed. Read the instruction and prepare all suppliers
before starting.
Verify that the existing primary sump pump is in good working

order. If the primary pump is questionable, replace with the same
or a higher HP pump. The primary pump is better to have a
vertical float switch or electrical switch. Tethered float switch
takes more sump pit space and might interfere with the
emergency pump.
 Manually operate your primary sump pump and pump out the
water in your sump pit. Do not let the pump run dry. This will
damage the pump.
Disconnect the primary sump pump power source before

attempting to install. Never handle a pump with wet hands or
when standing on wet or damp surface or in water. Fatal
electrical shock could occur.
Remove any silt or accumulated debris from the sump pit and surrounding area.

Close the inlet valve of the city water and open the tap to discharge water.Cut the city water pipe at a
proper position.
For Professional Technical Support call 1-844-242-2475
32 to 95° F (0- 35° C)
3