K2 Pumps ASP00001K El Manual Del Propietario página 7

OPERATION
1. Plug the pump plug into piggyback plug and
then plug it to GFCI plug, open the main valve.
3. Plug the primary sump pump after testing and be sure the power supply is on.
For Professional Technical Support call 1-844-242-2475
2. Pour water and test if the emergency pump can work
normally.
 Verify primary pump operation. Fill the sump pit with
enough water. The primary sump pump will start and
pump out the water then stop.
 Unplug the primary pump power cord plug from the power
supplier outlet.
 Verify emergency pump operation. Refill the sump pit
with water until the emergency pump float switch moves
to the upper end. The emergency pump should start and
pump out the water. If not, please check all the pipe
connections and adjust the position of the 2 rubber rings
on the float rod.
7