AO Smith AO-RO-RM-R Guia De Inicio Rapido página 4

AO-US-RO-MEM
MEMBRANE
REPLACEMENT
for use with AO-US-RO-MB-4000
FRESH
FILTERS.
CLEAN
WATER.
Fresh filters, obsessively engineered to
provide you with clean water. Take a
few minutes. Change your filters.
Whatever your water need – enjoy
the next round of clean water.
If you need help or have a question,
we've got you covered. Give us a call
at 877.333.7108.
INSTRUCTIONS:
Turn off the cold water valve under
1
the sink. Release the pressure from
the system by turning on the
filtration system faucet. Once there is
no water coming from the filtration
system faucet, you will be ready to
change the filters.
Disconnect the 1/4" red
2
hose from the drain port
on membrane filter
elbow by pushing down
on the collar while
pulling plug with your
other hand.
Remove and discard the
flow restrictor.
NEED HELP? GIVE US A CALL 877.333.7108
Remove the membrane cartridge from the
3
system by rotating the sump to the left and
pulling down.
1
2
Discard the old membrane cartridge.
4
Take the new membrane cartridge from
5
the packaging and remove the protective
cap from the head of the membrane.
Attach membrane cartridge to the bottom
6
of the top housing first, making sure all
connection points are aligned. Push the
top of the sump up and into the bottom
of the top housing and turn the sump
towards the right. Ensure the sump is
fully attached and locked.
1
2
Insert the new flow restrictor
7
into the red 1/4" tubing. Push
red tubing into the drain port
elbow on membrane filter.
IMPORTANT —
Be sure red tube and elbow
are inserted all the way.
Open the cold water valve. Purge the
8
system by opening RO faucet and
letting water flow through the system
for 24 hours.
Once the system has been purged,
9
turn off the RO faucet. Allow 2 hours
for pressure to build up in the system
and check for leaks. Your RO system is
ready to use.
Tested and Certified by IAPMO R&T lab and IAPMO
R&T against NSF/ANSI Standard 58 in model
AO-US-RO-MB-4000 as verified and substantiated
by test data. Please refer to Performance Data
Sheet for specific contaminant reductions.
• Conforms to NSF/ANSI Standard 58 for substances listed on the performance
data sheet. See performance data sheet for individual contaminants and
reduction performance: www.iapmo.org.
• Rated capacity: 12 months depending on contaminant levels & usage.
• Systems certified for cyst reduction may be used on disinfected water that
may contain filterable cysts
For use with municipally treated water only. Do not use
with water that is microbiologically unsafe or of unknown
water quality without adequate disinfection before or
after the system.
A. O. Smith Corporation | P.O. Box 1597
Johnson City, TN 37605-1597 | 877.333.7108
NEED HELP? GIVE US A CALL 877.333.7108