Heat Pro Plus How To Use; Heat Pro Plus Specifications; Operation Of The Heat Pro Plus; How To Attach Accessories To The Heat Pro Plus - Homeright HEAT PRO Manual Del Usuario

The HEAT PRO PLUS kit includes one hot air tool,
one concentrator nozzle and one scraper nozzle.
HEAT PRO PLUS Specifications
Wattage
Temperature
Volts
Amps
Output
Weight
Cord Length
Settings
Operation of the HEAT PRO PLUS
These are general guidelines for using the HEAT
PRO PLUS hot air tool. Every project is different,
so use these instructions as a starting point to
determine the best heat setting and distance to
position the hot air tool from your work.
Before plugging the HEAT PRO PLUS into an
electrical outlet, make sure the switch is in the
Off position.
1. Plug in to a standard outlet.
2. To start, slide the switch to either the Low or
High position. The motor-driven fan noise will
indicate the unit is running. The heating coil
will slowly turn red.
Note: Upon initial start up, smoke may appear
as the oils used in manufacturing burn off the
nozzle. This is normal and should stop within
one minute.
m Caution: If the blower motor in the hot air
tool does not turn on when the switch is set
to either Low or High, turn the switch to Off
immediately. The heating element will burn
out if the blower is not cooling it.
3. For instructions on how to strip paint, go
to section HOT AIR TOOL OPERATIONAL
GUIDELINES.
HEAT PRO PLUS
C820439B_MAN_Hot Air Tools.indd 8

HEAT PRO PLUS How to Use

up to 1200 Watts
Dual Temperatures
Low 500°F / High 1000°F
120 Volts
10 Amps
4100 BTU
1.75 lbs.
6 feet
High, Low, Off
4. To turn off the unit, slide the switch to the Off
position and unplug. Set the HEAT PRO upright
on a stable, level surface. This will speed up
the cooling process, because the air will flow
naturally upward over the heating element.
Allow the HEAT PRO to cool completely
before storing.
How To Attach Accessories to the
HEAT PRO PLUS
1. Set the HEAT PRO PLUS upright on a level
surface. Make sure tip is cool.
2. Set the accessory nozzle on the top of the
open nozzle and push firmly into place.
3. To remove, set hot air tool with nozzle facing
up. Wait for it to cool.
4. Pull the accessory nozzle off the top using a
twisting motion and straight pull.
5. Use only accessories designed for this hot
air tool.
Scraper
Deflector
Nozzle
ENGLISH 8
6/21/10 8:57 AM