Publicidad
Idiomas disponibles
Idiomas disponibles
reduce the risk of an electrical shock.
DANGER! If the equipment is not
earthed correctly then there is a risk of
electrical shock.
Do not modify the plug supplied with
the equipment, if it does not fit the wall
socket then get an electrician to install
an electrical socket that does.
This product must only be used on a
220-240 volt circuit, with an earthed
socket similar to that shown in Fig.A.
Always
observe
recommendations:
1
Never
use
recommended by the manufacturer.
2
Do not use the machine if the mains
cable becomes damaged or worn.
3
Keep the mains cable away from hot
surfaces.
4
Do not use the machine outdoors.
5
To unplug the machine, first put the
switch to the "0" position and then
unplug it from the wall socket.
SAFETY BREAKER.-
This model is equipped with an
electronic circuit breaker to protect both
the electronic and electrical circuits.
This safety device (fuse) will be
automatically triggered if the unit is
subjected to abnormal force or heat.
1.- Set switch (L), located on the
casing, to the "0" (OFF) position.
2.- Change the fuse (C) (7 Amp).
3.- Next, set switch (L) to the "I" (ON)
position and the unit will be ready for
the
following
accessories
not
use again.
Plug the unit into a wall socket with an
EARTH terminal. Set switch (L) to
Position [1].
ASSEMBLY INSTRUCTIONS.-
Take the unit out of the box and place
it on the floor as shown in Fig.1.
The assistance of a second person
is advisable for the assembly work.
Make sure that all of the pieces are
there:
(1) Platform column; (4) Handlebar;
(7)
Platform;
wheels; (35) Mains cable; (27) Allen
screw M-10x40; (25 ) Flat washer M-
10; (26) Safety washer security M-10;
(29) Allen screw M8x25; (6) Flat
washer M8; Allen key 4mm; Allen key
6mm; Allen key 8mm.
Follow these step-by-step assembly
instructions.
The assistance of a second person is
recommended when assembling this
platform. Position the platform as
shown in Fig.2, lifting and resting the
four feet on a table, for example.
1 At least two people are needed for
this step. When fitting the column, one
person should hold the column while
the other one follows the assembly
instructions. This will prevent any
possible accidents.
First take the column (1) and put it into
11
(40)
Transportation
Publicidad
