Machine Warnings; Prohibited Use; Starting The Machine - Bona Belt UX Manual De Funcionamiento Y Mantenimiento

Machine Warnings

Prohibited use

Children should be supervised to ensure that they do not play with the appliance. This
machine is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge unless they have
received instructions regarding the use and are supervised by a person responsible for
their safety.
This equipment is not suitable for collecting hazardous dust.
Using the machine to move objects or moving on an incline may cause injury or damage. The
machine must only be used to sand dry floors which are level or have a maximum incline of 2%.
DO NOT use the machine to sand steps and furniture.
Work surfaces may be seriously damaged if the machine is left turning on one point while the
tool is in contact with the surface. To avoid damaging the surface approach the cutting line
carefully.
DO NOT stop when lowering and raising the equipment, keep moving at constant speed.
18

Starting the Machine

Bona Belt UX Manual
To start the machine proceed as follows:
1.
Become familiar with the
machine and read all
instructions & safety notices.
Ensure that all operators
read this manual.
5.
Open the side guard (A).
2. 3.
If using DCS, connect tha Locate the power supply. The
adaptor supplied with the socket must be compatible
machine and DCS hose with the plug.
directly.
To avoid electrical hazards
If using a dust bag, place the the socket must be grounded
dast bag on the suction pipe with a 20 A fuse.
by tying the cord.
6. 7.
Lower the tensioning unit Insert the abrasive belt
using the drum tensioning (A), ensuring it protrudes
lever (A). approximately 2 mm from
the rubber drum area but
runs along the inside of the
tensioning unit.
Only use 750 mm x 203 mm abrasive belts.
EN
Bona Belt UX Manual
4.
Wind the cable around the
cable safety arm (A) to keep
it away from the path of the
machine.
8.
Tighten the drum using the
drum tensioning lever (A).
19