Machine Data Plate; Commencing Operation; Instructions For Assembly Following Transportation - Bona Belt UX Manual De Funcionamiento Y Mantenimiento

Introduction (Cont.)

Machine data plate

The following information can be found on the machine data plate:
1) Machine model
2) Safety symbols
3) Motor power
4) Supply voltage and frequency
5) Country of manufacture
6) Year of manufacture (see 8)

Commencing Operation

Instructions for assembly following transportation

To reassemble the machine after transportation, proceed as follows:
1.
2.
Open the belt guard after turning Position the motor in its
the screw counter-clockwise. housing.
12
Bona Belt UX Manual
7) Name of manufacture
8) Serial number. For example TA1915103
• The first two numbers refer to the year of manufacture
(19 =2019)
• The second group of three numbers indicates the day of
the year the machine was manufactured (151 = May 31
• The last two numbers indicate the progressive number of
machines produced that day of manufacture
(03 = 3 th machine produced that day)
Commencing Operation (Cont.)
Instructions for assembly following transportation (cont.)
3.
h )
Secure the motor by tightening the
knob (A).
5.
Close the belt guard and tighten
the screw.
The drum belt must have a 10.5 mm stretch with a center load of 30±3 N.
Belt tension can be adjusted using the screw.
The vacuum cleaner belt must have a 8 mm stretch with a center load of 18±2 N.
The belt tension can be adjusted using the belt tightener.
4.
Fit and stretch the belts.
6.
Pull the belt tightener (A) as
shown.
Excessive belt tension may cause the premature failure of the ball bearings.
Using the machine when not fully assembled may cause injury or damage to people or objects.
DO NOT use the machine when it is not fully assembled. Keep all fittings tightly closed. Maintain
machine settings in accordance with the specifications.
EN
Bona Belt UX Manual
13