Bona Belt UX Manual De Funcionamiento Y Mantenimiento página 11

Starting the Machine (Cont.)
9. 10.
Connect the plug to the Ensure the lever (A) is
socket. lowered and drum is raised
from the floor.
11.
To start the machine stand behind the handle, then...
Turn the knob on Hold it in this position until
the switch from the motor has reached a
"0" to "START" sufficient rotation speed
If starting the machine is difficult in winter when temperatures are very low remove the abrasive belt and start the
motor, letting it idle for several minutes. Replace the belt and repeat the start up operations described.
20
Bona Belt UX Manual
Release the knob, which will
automatically return to work
position "1"
Starting the Machine (Cont.)
12. 13.
Observe the operation of Close the side guard (A).
the abrasive belt. Follow the
procedures for 'Centering
the Abrasive Belt' on page
22. The belt must run inside
the tensioning unit (A) and
protrude by approximately
2mm from the rubber drum
(B).
15.
15) To stop the machine with a single phase motor:
Turn the knob
from "1" to "0"
A safety contactor is fitted to the machine. If the power fails when sanding the contactor is
activated automatically, stopping the machine from accidentally starting up when the power is
restored. To recommence sanding repeat the start-up operations described above.
Bona Belt UX Manual
14.
After lowering the lever (A),
commence sanding.
EN
21