Troubleshooting; The Engine Does Not Start - Husqvarna 324L Manual Del Usuario

Ocultar thumbs Ver también para 324L:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Maintenance
Make sure that the throttle trigger lock and the throttle works correctly from a
safety point of view.
Do a check of the stop switch to make sure that it works correctly.
Make sure that the cutting attachment does not rotate at idle speed.
Clean the air filter. Replace if necessary.
Examine the cutting attachment guard for damages and cracks. Replace the
guard if it has been exposed to impact or is cracked.
Examine the trimmer head for damages and cracks. Replace if damaged.
Make sure that the screws and nuts are tight.
Examine the engine, the fuel tank and the fuel lines for leaks.
Clean the cooling system.
Examine the starter and the starter rope for damages.
Examine the vibration damping elements for damages and cracks.
Clean the outside of the spark plug. Remove it and do a check of the electrode
gap. Adjust the gap to the correct distance (see,
page 16 ) or replace the spark plug. Make sure that the spark plug is fitted with a
suppressor.
Clean the outside of the carburettor and the space around it.
Do a check of the bevel gear to make sure that it is filled three-quarters with with
lubricant. Use special grease to fill if neccessary.
Clean or replace the spark arrestor mesh on the muffler (only applies to mufflers
without a catalytic converter).
Do a check of the fuel filter for contamination and the fuel hose for cracks or oth-
er defects. Replace if neccessary.
Do a check of all cables and connections.
Do a check of the clutch, clutch springs and the clutch drum for wear. Replace if
neccessary by an autorized service workshop.
Replace the spark plug. Make sure that the spark plug is fitted with a suppres-
sor.
Check and clean the spark arrestor mesh on the muffler (only applies to mufflers
without a catalytic converter).

The engine does not start

Check
Stop switch.
18

Troubleshooting

Possible cause
The stop switch is in the stop position.
To examine the spark plug on
Procedure
Set the stop switch to the start position.
Daily
Weekly
Monthly
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
1323 - 002 -
X
X
X
X
X

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido