Seal/Drain System Electrical Connections - Kohler K-1913 Guia De Instalacion

Receptor Tray

18. Seal/Drain System Electrical Connections

All Installations
This bath is designed to contain water, but small amounts of water will escape during normal operation.
When the bath is functioning properly, you may see:
Water along the access panel or in the receptor tray, particularly after the seal deflates.
Water coming out of the accumulator drain tube and entering the receptor tray and
receptor tray drain during and after filling the bath.
Some water going over the door seal and entering the receptor tray when the bather
moves abruptly in a bath completely filled to the overflow.
A small amount of water temporarily dripping from the bottom of the door. This happens
when water that runs over the top of the door seal enters the gap between the primary
and secondary seals. The water follows the path to the lowest point and may drip into the
receptor tray there until the water level stabilizes, at which point the dripping will stop.
WARNING: Risk of electric shock. Connect the controller to a properly grounded, grounding-type
receptacle protected by a Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device
(RCD). Do not remove the plug grounding pins. Do not use grounding adapters.
NOTE: The model number is printed on a label near the controller. This label also identifies the electrical
rating.
NOTE: Refer to the "Heated Surface Electrical Connections (some models)" section if your product is
equipped with the heated surface feature.
1128532-2-H
Bath Drain
Receptor
Tray Drain
Secondary Drain Valve
32
Accumulator Valve
and Drainage Line
Kohler Co.