GYS STARTPACK TRUCK Manual Del Usuario página 15

Translation of the original instructions
STARTPACK TRUCK & STARTPACK TRUCK MOBILE
BATTERY NOT COVERED BY WARRANTY
Batteries are live parts, their life depends on maintenance. After each use of this starter, it is essential to recharge the
internal batteries. Storage in places with high temperatures greatly reduces the battery charge. In the case of prolonged
non-use, it is strongly recommended to recharge the batteries before use. In general, we recommend leaving the
product plugged in continuously to maintain the batteries at their best performance.
This product is equipped with 2 high performance batteries if the maintenance instructions are not followed the batteries
can deteriorate irreversibly over time.
For this reason the STARTPACK TRUCK batteries are excluded from the warranty.
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
• The retractable handle for the mobile version
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
STARTPACK DISASSEMBLY
Disassemble the product is useful especially to replace batteries. Proceed as such :
Ensure to turn the switch OFF and disconnect all the accessories plugged to the cigarette
lighter plug.
Startpack Truck standard
• Unscrew the back panel (18 screws) and remove it.
Startpack Truck mobile
1
Put the booster on the front side against the ground, then:
• Remove the wheel to pull out a screw from the end of the axis.
• Disassemble the stand plastic block from the axle below the booster (2 screws).
• Remove the wheel axle by dragging it sideways.
• Pull out the output cables wound on their support. Pull out all the assembly screws (19 screws) from the booster's
2 hulls and remove the back cover.
EN
2
15