Device Switch On/Off - Bartscher 280PRO Manual Del Usuario

5.2.2 Device switch on/off

WARNING! Risk of burns!
During the flame ignition, never lean over the device.
High flames from this area my lead to severe burns.
Pilot flame ignition (Fig. 7)
Press the burner knob and turn left to MAX position (C), hold the knob pressed
•
and ignite the pilot flame with a match. Hold the burner knob pressed for a few
more seconds to allow heating up of the thermocouple. If the pilot flame goes
out, repeat the process.
Main burner ignition (Fig. 7)
To ignite the main burner, turn the burner knob left to MAX position (C)
•
or further, until the lowest MIN position (D).
Heat output may be adjusted between these two settings.
•
Switching off (Fig. 7)
In order to switch the main burner off, turn the burner knob right to position (B), thus
•
leaving only a control valve switched on. Turn the burner knob to position (A), to
switch the pilot flame off.
- 45 -