Basic Operation Procedures; Basic Operation Practices - Skymsen CR-4L Manual De Instrucciones

4.1 Basic Operation Procedures

4.1.1 Danger
Some parts of the electric devices are connected to high voltage points. These parts when
touched may cause severe electrical shocks or even be FATAL.
Never touch commands such as buttons, switches and knobs with wet hands, wet clothes
and/or shoes. By not following these instructions operator could be exposed to severe
electrical shocks or even to a FATAL situation.
4.1.2 Warnings
The operator has to be well familiar with the position of ON/OFF Switch to make sure the
Switch is easy to be reached when necessary. Before any kind of maintenance, physically
remove plug from the socket.
Provide space for a comfortable operation thus avoiding accidents.
Water or oil spilled on the floor will turn it slippery and dangerous. Make sure the floor is
clean and dry.
Before giving any manual command (switch, buttons, turn keys or lever) be sure the
command is the correct one. Check this manual for further details if necessary.
Never use a manual command (switch, buttons, lever) unadvisedly.
If any work is to be made by two or more persons, coordination signs will have to be given
for each operation step. Every step of the operation shall be taken only if the sign has been
made and responded.
4.1.3 Advices
In case of power shortage, immediately turn the machine OFF. Use recommended or
equivalent lubricants, oils or greases.
Avoid mechanical shocks as they may cause failures or malfunction.
Avoid penetration of water, dirt or dust into mechanical or electrical components of the
machine.
DO NOT MODIFY original characteristics of the machine.
DO NOT REMOVE, TEAR OFF or MACULATE ANY SAFETY or IDENTIFICATION LABELS stuck
on the machine. If any label has been removed or is no longer legible, contact your nearest
dealer for replacement
13