Electric Brake; Hex Wrench Storage - Makita XSC03 Manual De Instrucciones

Sierra para metal inalámbrica
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Lighting the lamp
CAUTION:
Do not look in the light or see the
source of light directly.
To turn on the lamp without running the tool, pull the
switch trigger without pressing the lock-off lever.
To turn on the lamp with the tool running, press and hold
the lock-off lever and pull the switch trigger.
► 1. Lamp
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Dust box
CAUTION:
Do not touch saw dust and the
dust box with bare hands immediately after the
operation. They may be extremely hot and could
burn your skin.
CAUTION:
Do not cut the material on which
thinner, gasoline, grease, or other chemicals are
applied. The saw dust of such materials can damage
the dust box and result in breakage which can cause
personal injury.
CAUTION:
Wear eye protection or goggle
when emptying the dust box.
Saw dust is collected into the dust box. Periodically
dump the saw dust in the dust box before it gets full.
Push the lever on the dust box to open the lid. Dump
the saw dust while the rear of the tool faces downward.
► 1. Lid 2. Lever

Electric brake

This tool is equipped with an electric blade brake. If the
tool consistently fails to quickly stop the circular saw
blade after switch lever release, have tool serviced at a
Makita service center.
1
substitute for blade guard. NEVER USE TOOL
WITHOUT A FUNCTIONING BLADE GUARD.
SERIOUS PERSONAL INJURY CAN RESULT.
ASSEMBLY
switched off and the battery cartridge is removed
before carrying out any work on the tool.

Hex wrench storage

When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
► 1. Hex wrench
2
1
8 ENGLISH
CAUTION:
The blade brake system is not a
CAUTION:
Always be sure that the tool is
1

Publicidad

Tabla de contenido
loading

Tabla de contenido