Electric Brake; Hex Wrench Storage - Makita 5402NA Manual De Instrucciones

Electric brake

This tool is equipped with an electric blade brake. If the
tool consistently fails to quickly stop blade after switch
trigger release, have tool serviced at a Makita service
center.
The blade brake system is not a substitute for lower
guard. NEVER USE TOOL WITHOUT A FUNCTIONING
LOWER GUARD. SERIOUS PERSONAL INJURY CAN
RESULT.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Removing or installing saw blade
2
001969
CAUTION:
Be sure the blade is installed with teeth pointing up
•
at the front of the tool.
Use only the Makita wrench to install or remove the
•
blade.
Release the lock lever of blade steady device.
To remove the blade, press the shaft lock so that the
blade cannot revolve and use the wrench to loosen the
hex bolt counterclockwise. Then remove the hex bolt,
outer flange and blade.
To install the blade, follow the removal procedure in
reverse. BE SURE TO TIGHTEN THE HEX BOLT
CLOCKWISE SECURELY.
1 2
001970
1. Shaft lock
1
2. Hex wrench
1. Hex bolt
2. Outer flange
3. Inner flange
4. Saw blade
3
4
After installing the blade, lock the lock lever.
When changing blade, make sure to also clean upper
and lower blade guards of accumulated sawdust. Such
efforts do not, however, replace the need to check lower
guard operation before each use.
CAUTION:
The inner flange has a 25 mm (63/64") diameter on
•
one side and a 25.4 mm (1") diameter on the other.
The side with 25.4 mm (1") diameter is marked by
"25.4".
Use the correct side for the hole diameter of the
blade you intend to use. Mounting the blade on the
wrong side can result in dangerous vibration.
1
25.4
1. Mounting shaft
2. Inner flange
3. Outer flange
4. Hex bolt
5. Blade
001971

Hex wrench storage

2
001972
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
To remove the hex wrench, push the shorter side of it out
with your finger. Then remove the hex wrench.
001973
8
2 3 4
25 25
5
1. Lever
2. Hex wrench
1