Tensioning The Belt Checking/Adjusting/Replacing Belts - HOLZMANN MASCHINEN HOB 260ABS Instrucciones De Servicio

18.2.4 Tensioning the belt checking/adjusting/replacing belts

The belt tension is set correctly for new machines by the manufacturer. Due to elongation of the
belts over the running time, the belt must be retensioned.
To check/adjust or replace the belt, the belt/chain cover must be removed. Loosen the screws
and remove the belt and chain cover.
HOLZMANN MASCHINEN GmbH
CLEANING, MAINTENANCE, STORAGE, DISPOSAL

 Loosen the gib (1) and remove the cutter knives
 Clean gib (1) and knives (2).
 Replace sharpend/new cutter knive (2) and gib
 Slightly tighten the locking screw (3) and and
 Place the setting gauge on the planning shaft and
 Tighten the gib (1). (Recommended minimium
 Do not use cutter knives with a height of less
 Repeat procedure for all cutter knives.
 The Allen keys required for tensioning or
www.holzmann-maschinen.at
 Disassembly planer fence
 Pull out and turn the handle (3) to release the
table lock and swivel the back planer table (4)
upwards.
NOTICE: To release the fixing of the back planer
table (4) and tilt it down again, pull out the
engaged safety lever (5).
(2).
(1).
perform the adjustment procedure.
adjust the correct height for the knives using the
2 Allen-screws (4). The maximum blade overhang
must not exceed 1.1 mm.
tightening torque 10Nm).
than 18 mm due to the too small clamping
surface.
replacing the drive belts can be found in the
toolbox.
53
HOB 260ABS