Alternate Final Assembly, Without Light Kit; Assembly Of Handheld Remote Control. Pgs - Craftmade Bellows II Guia De Instalacion

9. Alternate Final Assembly, Without Light Kit.

If you do NOT wish to use the light kit, remove
1 screw from motor plate on underside of
motor assembly and partially loosen the other
2 screws. Align slotted holes in small fitter
plate with loosened screws in motor plate,
allowing molex connections from motor
assembly to come through hole in middle of
small fitter plate. Twist small fitter plate to lock.
Re-insert screw that was previously removed
and securely tighten all 3 screws with a Phillips
screwdriver.
Remove 3 screws from outer edge of
fitter plate.
Align holes in metal cover with holes in outer
edge of small fitter plate. Secure metal cover
with 3 screws that were just removed.
10. Assembly of Handheld Remote Control.
IN ORDER TO USE THE HANDHELD REMOTE
CONTROL, PLEASE CONTINUE WITH SECTION 10 for
remote control assembly instructions. If you have
already installed the wall control but do not wish to
use the handheld remote control, please proceed to
Section 11.
Gently pull on remote control cover to separate
top and bottom parts. [Refer to diagram 1.]
["Assembly of Handheld Remote Control"
continued on next page.]
small
diagram 1
page 8
motor assembly
motor plate
small fitter plate
molex connections
motor assembly
small fitter
plate
metal cover
remote control
cover
(top)
(bottom)